The keycaps are made out of PBT with dye-sublimated legends. This keyboard uses a special colourway that is similar to Olivetti.
The upper case is made out of a single piece of beige ABS plastic. The plastic is textured due to the molding process that is used to create the upper case. The case is a grey color similar to Industrial Model M keyboards.
The lower case is molded from the same ABS plastic as the upper case. A set of slots are located in the lower case that joins the two halves together. The feet that are integrated into the lower case are flush with the lower case when retracted.
The switch plate is made out of stamped steel. The plate is bent on either so that it can be mounted to the lower case. The plate is painted with a thin layer of black paint. The paint is then protected by a thin layer of oil to prevent rust.
The PCB is a double-sided PCB with all traces on the backside of the PCB. The keyboard uses a switch that selects which type of terminal that the keyboard will connect to.
The cable is an RJ cable that ends in a 4P4C connector.
Top
Model #
Switch
PCB Markings
Pinout/Jumpers
Model # / Jumpers
Bottom
Inside
Daughterboard
IC
PCB Markings
Bottom of Keycap