Kroy 190

Overview

This keyboard was OEMed for Kroy.

• Switches

• Keycaps

• Upper Case

• Mounting Plate

• PCB

• Back Plate

• Cable

Switches

Keycaps

The keycaps are made out of PBT with dye-sublimated legends. These keycaps are unique to this keyboard as they use a different font and unique colorway. The keycaps can be found in two different versions. One with normal legends and another one with terminal like legends.

The keyboard with terminal like legends also have front facing legends as well the describe other operations that can be performed with the keys.

Upper Case

The upper case is made out of a single piece of beige ABS plastic. The plastic is textured due to the molding process that is used to create the upper case.

Lower Case

The cases is made out of a single piece of beige ABS plastic. The plastic is textured due to the molding process that is used to create the lower case. The lower case feet are super flimsy and feel like that they are going to break when moved from the retracted to the out position. The lower case also contains a cable cutter where the cable can be routed to either side of the keyboard.

Switch Plate

The switch plate is made out of stamped steel. The plate has deeper stamping around the switches so that the entire switch plate could be produced with less material. The plate is only coated with a clear coat.

PCB

The PCB is a double-sided PCB with all traces on the backside of the PCB. The controllers found on the PCB vary, some later models have been found with both Toshiba and Mitsubishi controllers.

Cable

The cable is a long coiled cable about 2 meters long when fully stretched. The cable terminates on one end with a PS2 connector and the other end with a 6 pin molex connector.

Gallery

Advertisements / Manuals