Memorex RT-101

Overview

This keyboard was OEMed for Memorex.

This keyboard was produced for Memorex 7000 systems. Memorex keyboards use a slightly different top and bottom case. Certain Memorex keyboards included a single large foot on the back of the keyboard for height adjustment.

Switches
Keycaps
Upper Case
Mounting Plate
PCB
Back Plate
Cable

Switches

Keycaps

The keycaps are made out of PBT with dye-sublimated legends. These keycaps are unique to this keyboard as they use a different font and unique colorway. The keycaps differ via the non stepped "Caps Lock" keycap.

Upper Case

The upper case is made out of a single piece of beige ABS plastic. The plastic is textured due to the molding process that is used to create the upper case. The pen rail on the keyboard's upper case contains a higher than normal so that it almost sits flush with the top row of the keycaps.

Lower Case

The cases is made out of a single piece of beige ABS plastic. The plastic is textured due to the molding process that is used to create the lower case. The lower case foot this foot can be adjusted to another angle for a different typing angle. The foot has a thin section where it can be folded to lock into the notched on the bottom of the lower case.

Switch Plate

The switch plate is made out of stamped steel and coated in black paint. The plate extends further than usual as the plate has a thicker chin that interacts with the bottom and top case.

PCB

The PCB is a double-sided PCB with all traces on the backside of the PCB.

Cable

The cable is a long coiled cable about 2 meters long when fully stretched. The cable terminates on one end with a 5 pin din connector and the other end with a 6 pin molex connector.